What

One Fujitsu split got a full strip clean. The other had a burnt board, and we sent it to warranty.

What's in a Split System Strip Clean: A Real Minto Job

What's Involved In A Split System Strip Clean

A normal service cleans the filters, checks the system and takes readings. A strip clean goes further. The indoor unit is taken apart so the fan barrel, casing and coil can be properly cleaned, not just sprayed.

You need one when there's heavy build-up inside: black spots on the fan, a musty smell, or dust and mould blowing out. It takes a fair bit longer than a standard service.

Our strip clean, step by step

  1. Isolate the power and protect the wall and floor.
  2. Remove the covers, filters and louvres.
  3. Take out the fan barrel where the model allows, or clean it in place where it doesn't.
  4. Chemically clean the coil and rinse it.
  5. Clean the casing, drain tray and internal parts.
  6. Reassemble, test the system and check it's running as it should.

What not to do

  • Don't spray store-bought cleaner into a running unit. It can damage the electrics.
  • Don't pull a split apart yourself. Parts break easily and there's mains power inside.
  • Don't pay for a repair on a newer unit before checking the warranty. We referred the dead unit here to Fujitsu.

See air con smells bad and split system repairs.

The Job

  • Suburb: Minto
  • Job: Split system service and diagnostic
  • Systems: Two Fujitsu wall splits, front unit 9.4kW, R32

The customer booked a service on two split systems.

What We Found

The rear unit was badly built up inside, so it got a full strip clean.

The front unit was dead. Inside, there were burn marks on the indoor circuit board at the fan motor plug. That's a fault in the unit, not something a service causes or fixes.

Burn marks on a Fujitsu split system indoor circuit board
Burn marks on the indoor board.
Fujitsu split system stripped down for a full clean
The rear unit, stripped for cleaning.

What We Did And Recommended

The rear unit was cleaned and is running well. For the front unit, we didn't attempt a repair. It's young enough that it should be covered, so we referred it back to the installer or Fujitsu for warranty.

Pointing you at a warranty claim instead of billing you for a board is just the right call.

More on split system repairs, Fujitsu repairs, and air conditioning in Minto.

Jay's Air Conditioning white icon logo showing the flame and tick brand symbol on a light grey background

FAQ

Common Questions

FAQ

The indoor unit is taken apart so the fan barrel, casing and coil can be properly cleaned. It’s deeper than a standard service and takes longer.

Black spots on the fan, a musty smell, or dust and mould blowing out are the usual signs.

It had burn marks on the indoor board at the fan motor plug, and it was young enough to be under warranty. We gave the customer the model and serial numbers to take to the installer or Fujitsu.

Our Standard Service is $250+GST for the first unit and $110+GST for each extra unit. A heavily built-up unit that needs a strip clean takes longer, so we’ll let you know on the day.

Get A Report Like This For Your System

Every Standard Service ($250+GST, $110+GST for each extra unit) comes with a written report like this one, with readings and photos, emailed to you the same day. Diagnostics are $250+GST and come with a written report too.

Give us a call on (02) 9820 4500 or book online. Our own crew, not subbies. NSW contractor licence 273312C, ARCtick AU13058. Servicing Sydney since 1991.

See all our service reports